Shunze 學園 (http://www.shunze.info/forum/index.php)
|- Cyberoam (http://www.shunze.info/forum/board.php?boardid=33)
|-- 《分享》在Cyberoam上使用Sophos AP (http://www.shunze.info/forum/threadid.php?boardid=33&threadid=2049)


作者: shunze 發表時間: 2017-08-17, 14:52:

《分享》在Cyberoam上使用Sophos AP

網路上查不到Cyberoam在哪個韌體版本後支援Sophos AP?
不過我們公司的Cyberoam 10.6.4 MR1經順子測試後,發現是支援的!
以下就設定方式做個筆記。

  1. 先在通用設定中,確認是否已有AP的韌體。
    若沒有,會出現如下頁面,然後按下頁面中的Download AP Firmware進行韌體下載。



    下載完成後,會變更為如下頁面。



    於此頁面中啟用無線與設定可連接AP使用的ZONE。

  2. Sophos AP接上後,給它一點時間,AP才能從Cyberoam上抓到對應的韌體。



    靜候一會兒,AP會出現在Pending區,這時可以著手設定無線網路配置。



  3. 在Wireless Network中配置欲使用的網路類型。
    支援基本的Gateway Mode、Bridge Mode與Bridge VLAN Mode幾個模式。



    無線網路設定好後,回到AP畫面,按下打勾圖示,建立與剛才設定的無線網路連結。



    然後AP會跳到Active/Inactive區域,這時的狀態是空白的。



    之後AP會下載設定並進行套用,過程中會重開機幾次,
    狀態也會出現不同變化。





  4. 在AP變成“啟動”後.使用者的無線裝置就可以找到SSID進而使用此無線網路。



    而SSID、AP與使用者的關聯就可以在總覽中查看的到。




以上Cyberoam使用Sophos AP的設定的簡單分享。


PS.
This feature is supported for the following Sophos AP models: AP 10, AP 15, AP 30, AP 50, AP 55 and AP 100.
Wireless Protection is not supported in Cyberoam ‘wi/wiNG’ series appliances and 10iNG/15iNG appliance models.

Powered by: Burning Board 1.1.1 2001 by WoltLab
Taiwan Translation by Achi